Siemens SINUMERIK 840C Installation Instructions Manual page 588

09.95
Bit 10 - SW 4 Command variable
Bits 11-12
Bit 13
Bit 14
Bit 15
11006
This machine data contains the warnings of a digital drive. It is stored on an axis-specific basis
at the interface between the SERVO and the 611D.
Bit 0
Bit 1 - SW 4
Bit 2 - SW 4
Bit 3 - SW 4
Bits 4-13
Bit 14
Bit 15
11007
This machine data contains the warnings of a digital drive. The machine data is stored on an
axis-specific basis at the interface between the SERVO and the 611D. For bits 6 to 15 there is
no evaluation or connection to the PLC.
Bit 0 - SW 3
Bit 0 - SW 4
Bit 1 - SW 3
Bit 1 - SW 4
Bit 2 - SW 3
©
Siemens AG 1992 All Rights Reserved
SINUMERIK 840C (IA)
More user manuals on
(Bit 11:) Master-slave operation setpoint
Travel against fixed stop setpoint
C axis mode setpoint
Sign of life
Default value Lower output limit
– 0000
DC link (off ˆ = DC link fault)
DC link voltage emergency retraction ( MD 1634)
Emergency retraction/generator mode active
Generator speed < minimum speed
Assigned to or reserved for internal system functions
Motor temperature warning
Heat sink temperature warning
Default value Lower output limit
– 0000
Programmable message 1
Ramp-up completed
Programmable message 2
I M I< M
d dx
Programmable message 3
ManualsBase.com
7 Drive Machine Data (SIMODRIVE Drive MD)
7.4.3 Diagnosis/service MD (data description - as from SW 3)
Status class 2
Upper output limit
FFFF
Status class 3
Upper output limit
FFFF
6FC5197- AA50
0 : torque
1 : speed
0 : off
1 : on
Active
after ramp-up
of 611D link
Units
Hex
0 : off
1 : on
0 : on
1 : off
0 : off
1 : on
Active
after ramp-up
of 611D link
Units
Hex
0 : off
1 : on
7–173