Siemens SINUMERIK 840C Installation Instructions Manual page 362

09.95
Application:
A gearbox grouping can be configured with the G401 command. If the type of link has not
been defined in the G401 command, the default value from MD 1456* is taken.
Example:
G401
If "No default" (MD 1456* = 0) has been entered and no link type has been entered in G401,
reset alarm "GI CONFIGURATION illegal" is triggered.
1460*-
1480*
These MD have the same meaning as MD 392*, see also "Functional Descriptions: Parameter
set switchover".
1484*-
1508*
These MD have the same meaning as MD 1272*, see also "Functional Descriptions:
Parameter set switchover".
1512*-
1536*
These MD have the same meaning as MD 256*, see also "Functional Descriptions: Parameter
set switchover".
1540*-
1564*
These MD have the same meaning as MD 204*, see also "Functional Descriptions: Parameter
set switchover".
©
Siemens AG 1992 All Rights Reserved
SINUMERIK 840C (IA)
More user manuals on
X, Y: leading axes, Z: following axis, no link type.
X Y Z
Time constant symmetrizing filter 3rd - 8th parameter set
Default value Lower input limit
0
Time constant setpoint filter 2nd - 8th parameter set
Default value Lower input limit
0
Scaling factor max. velocity 2nd - 8th parameter set
Default value Lower input limit
10 000
Exact stop limit coarse 2nd - 8th parameter set
Default value Lower input limit
40
40
ManualsBase.com
6 NC Machine Data (NC MD), NC Setting Data (NC SD)
(as from SW 4)
Upper input limit
+0 1 000
(as from SW 4)
Upper input limit
0 1 000
(as from SW 4)
Upper input limit
1 99 999 999
(as from SW 4)
Upper input limit
+0 16 000
+0 99 999 999 (SW 4.4
and higher)
6FC5197- AA50
6.7 Axis-specific MD 2 (axial data 2)
Active on
NC Stop
Units
0.1 ms
Active on
at once
Units
0.1 ms
Active in
channel of
mode group
in STOP
Units
mm inch degr.
–––– –––– ––––
min min min
Active on
NC Stop
Units
units (MS)
units (MS)
6–177