Siemens SINUMERIK 840C Installation Instructions Manual page 222

07.97
200*
Default value
Digit No.
Example for structure
of a value in
MD 200*
Digit No. 1, 0: Local axis number
The control automatically enters the local number of the axis here.
Digit No. 3, 2: Code digital drive
Code 10(-15) assigns the address to 611-D (611-D servo loop or digital setpoint channel).
Codes 1-9, 11-15 are reserved for expansions in the future and are interpreted as for 00 or 10.
The code must be entered by the user.
Digit No. 5, 4: SPC/HMS setpoint output
Permissible values for digital drives are the values 01 and 02:
01:
02:
Digit No. 7, 6: Logical drive number / Servo loop module number
The logical drive number is entered here for digital drives.
Input range (00..15):
Input range (00..30):
(SW 5 and higher)
Notes:
• See Section 5, Machine Data Dialog, for the servo loop assignment.
• Up to SW 4: Only 14 real axes can be defined with a fictitious axis.
©
Siemens AG 1992 All Rights Reserved
SINUMERIK 840C (IA)
More user manuals on
1st measuring system connection (as from SW 3)
Lower input limit
0 +0
7 6
0 1
Logical No. of 611-D
drive no.
(611-D)
PCU slot 1 (for MSD permanent indirect measuring system)
PCU slot 2 (free direct or indirect measuring system)
00:
01..15:
00:
01..30:
ManualsBase.com
6 NC Machine Data (NC MD), NC Setting Data (NC SD)
Upper input limit
15021015 (up to SW 4)
30021030 (as from SW 5)
5 4 3 2 1
0 1 1 0 0
Code Axis number of servo loop module
servo loop digital (entered by the control)
connection drive
No submodule available
According to logical drive number
For more detailed information see MDD
No submodule available
Logical drive number
6FC5197- AA50
6.4 Axis-specific MD 1 (axial data 1)
Active on
Power On
Units
–
0
0
6–37