Siemens SINUMERIK 840C Installation Instructions Manual page 79

4 MMC Area Diagnosis
4.3 Drive service displays for spindle (MSD) and axis (FDD) – as from SW 3)
Speed setpoint
smoothing actual value word 1 (drive MD 11002.11).
Ramp-function
generator rapid stop
V/F mode
2nd momentary limit
actual value
Integrator inhibit
actual value
Motor temperature
warning
Heat sink temperature
warning
Programmable
messages (SW 3)
Ramp-up
completed (SW 4)
IM I < M
d dx
In I < n
act min
In I < n (SW 4)
act x
n < n (SW 4)
set act
Variable message
function (SW 4)
Position actual value
Speed actual value
Speed setpoint
Capacity utilization
Variable message
function (SW 4)
Smoothed current
actual value (SW 4)
4–16
More user manuals on
This display field contains the status of speed setpoint smoothing of cyclic status
This display field contains the status of ram-function generator rapid stop of cyclic
status word 1 (drive MD 11002.9).
Possible display range: off or on
This display field contains the status of V/F mode of cyclic status word 2 (drive
MD 11003.12).
Possible display range: off or on
This display field shows the status of 2nd momentary limit of cyclic status word 1
(drive MD 11002.10).
Possible display range: off or on
This display field shows the status of the integrator inhibit of cyclic status word 1
(drive MD 11003.6).
Possible display range: off or on
This display field shows the state of the motor temperature warning
(drive MD 11006.14).
Possible display range: off or on
This display field shows the state of the heat sink temperature warning
(drive MD 11006.15).
Possible display range: off or on
This display field shows the status of programmable messages 1–6
(drive MD 11007.0–5).
Possible display range: off or on
This display field shows the current status of the message Ramp-function
procedure completed (drive MD 11007.0).
(SW 4) This display field shows the current status of the message IM
11007.1).
(SW 4) This display field shows the current status of the message In
11007.2).
This display field shows the current status of the message In
11007.3).
This display field shows the current status of the message n
11007.4).
This display field shows the current status of the message
Variable message function (drive MD 11007.5).
This display field shows the current positional actual value (SW 4: drive MD
12000). It depends on the position control of the rotary axis (NC MD 5640.5) and
the position control resolution (NC MD 18000.0–3).
This display field contains the current speed actual value of the motor (SW 3:
drive MD 2/SW 4: drive MD 1707).
This display field contains the current speed setpoint of the motor (SW 3: drive
MD 1/SW 4: drive MD 1706).
This display field shows the capacity utilization of the main spindle drive. Up to
the rated speed, the ratio torque to maximum torque is displayed and above the
rated speed, the ratio performance to maximum performance is displayed
(SW 3: drive MD 4/SW 4: drive MD 1722).
This display field shows the current status of the message Variable message
function (drive MD 11011).
This display field shows the smoothed current actual value in percent
(drive MD 1708).
ManualsBase.com

Siemens AG 2001 All Rights Reserved 6FC5197–jAA50
09.95
I < M (drive MD
d dx
I < n (drive MD
act min
I < n (drive MD
act x
< n (drive MD
set act
SINUMERIK 840C (IA)