Comments - Siemens SINUMERIK 840C Installation Instructions Manual

Hide thumbs Also See for SINUMERIK 840C:

Table of Contents

Comments

NC MD 1808* bit 3: – Software limit switch and leadscrew error compensation are

Reference point approach with a SIPOS absolute encoder is only possible when NC MD

1808* bit 3 has been reset.

Information as to whether the SIPOS absolute encoder is in the same or opposite

direction as the machine system is required by the control for calculating the absolute

value without reference point approach. Once the SIPOS absolute encoder has been

synchronized it is very easy to determine the direction of the SIPOS absolute encoder.

This is done by traversing the axis concerned to any desired position and starting up the

If, after setting up, positive approach and POWER ON, a larger absolute encoder value is

displayed, the system is in the same direction and does not have to be corrected. If a

smaller absolute encoder value is displayed, NC MD 1808* bit 2 = 1 must be set. The

correct position is then displayed after the next POWER ON.

If the mechanical traverse direction is changed with NC MD 564*, NC MD 1808* bit 2

must also be adapted correspondingly.

SINUMERIK 840C (IA)

More user manuals on

– The leadscrew error between the reference point and the

absolute position are included in the calculation.

ManualsBase.com

12.11.1 SIPOS absolute encoder up to SW 4

6FC5197- AA50

12 Functional Descriptions

Simodrive 611-d