Siemens SINUMERIK 840C Installation Instructions Manual page 248

09.95
3840,6-7
388*
Hammering or kneading machines are used for manufacturing axially symmetrical parts using a
forming process. The design of these machines sometimes necessitates traversing of an X'
path although an X path was programmed.
The weighting factor is entered in NC MD 388* and can be anything within the range
+0,00001 and+99,999999.
NC MD 388* is evaluated as follows:
The value zero is interpreted as weighting factor 1, so that the programmed path and the path
to be traversed are identical. The weighting factor of the axis concerned is multiplied by the
programmed path to produce the path to be traversed.
Conditions:
a) All other NC MD (in units [IS]) must be entered in the programmed system (X).
b) All other NC MD (in units [MS]) must be entered in the refined system (X').
c) The actual-value display (except in the Service displays), zero offsets, tool offset, PRESET
offset, etc., relate to the programmed system.
d) The programmed F value relates to the programmed system.
e) If the programmed or specified speed exceeds the permissible axis speed in the refined
system or cannot be converted into the internal computing format, alarm 2031 ("Weighting
factor too high") is set and both machining and NC Start inhibited.
f) The weighting factor is effective in all modes.
g) The weighting factor is not effective in the case of rotary axes.
©
Siemens AG 1992 All Rights Reserved
SINUMERIK 840C (IA)
More user manuals on
Drive/servo loop module No.
Default value Lower input limit
0
Weighting factor for path conversion
Default value Lower input limit
0
2 integer places
6 decimal places
(leading zeroes may be omitted)
ManualsBase.com
6 NC Machine Data (NC MD), NC Setting Data (NC SD)
Upper input limit
0 30
Upper input limit
+0 99 999 999
6FC5197- AA50
6.4 Axis-specific MD 1 (axial data 1)
Active on
Units
Active on
All chan. of
mode gr. in
STOP
Units
–
6–63