Siemens SINUMERIK 840C Installation Instructions Manual page 649

9 Drive Servo Start-Up Application (as from SW 3)
9.3.3 Signal waveforms of function generator (as from SW 3)
D Ramp 1 (position setpoint)
Conditions
Note
Erläuterung
9–28
More user manuals on
Position
s
A
Speed
character-
istic
v
O
Fig. 9.9
Operating mode
Signal type
ESD
RD
MD
A
O
Set acceleration is very high (speed characteristic).
The axis/spindle is traversed at the constant speed offset during the setting time
and after ramping according to the position ramp. The speed setpoint increases
during the position ramp time.
The acceleration set in the NC MD generally applies to the signal waveform of
the speed characteristic. To obtain the above signal waveform, a very high value
must be set in this NC-MD to ensure step changes in the speed.
ManualsBase.com
RD
ESD
: Position setpoint
: Ramp
: Settling time
: Ramp time
: Measuring time
: Amplitude
: Speed offset

Siemens AG 2001 All Rights Reserved 6FC5197–jAA50
MD
SINUMERIK 840C (IA)
09.95
10.94
t
t