Siemens SINUMERIK 840C Installation Instructions Manual page 382

09.95
2430*-
2433*
Default value
2434*-
2441*
Default value
These MDs are used to correct gear-stage-related offsets between the zero mark and
reference position, see functional description of ""Ratio" parameter group".
2442*-
2448*
These MD have the same meaning as MD 465*, see also functional description of parameter
set switchover.
2449*-
2456*
2457*-
2463*
Default value
These MD have the same meaning as MD 467*, see also functional description of parameter
set switchover.
2464*-
2470*
Default value
These MD have the same meaning as MD 486*, see also functional description of parameter
set switchover.
©
Siemens AG 1992 All Rights Reserved
SINUMERIK 840C (IA)
More user manuals on
Zero mark correction + as from SW 4
Lower input limit
0 - 999 999
Zero mark correction - as from SW 4
Lower input limit
- 999 999
0
16 000 (as from SW 4.4)
Feedforward control factor 2nd - 8th parameter set
Default value Lower input limit
0
Feedforward control factor D component as from SW 4
Default value Lower input limit
0
Time constant symm. filter 2nd - 8th par. set as from SW 4
Lower input limit
0 0
Time constant setpoint filter 2nd - 8th par. set
Lower input limit
55 0
ManualsBase.com
6 NC Machine Data (NC MD), NC Setting Data (NC SD)
5th to 8th parameter set
Upper input limit
999 999
16 000 (as from SW 4.4)
1st to 8 th parameter set
Upper input limit
999 999
16 000 (as from SW 4.4)
as from SW 4
Upper input limit
0 1 000
1st to 8 th parameter set
Upper input limit
0 1 000
Upper input limit
9 999
1 000 (as from SW 4.4)
as from SW 4
Upper input limit
1 000
16 000 (as from SW 4.4)
6FC5197- AA50
6.9 MDs for parameter set switchover
Active on
NC Stop
Units
units (MS)
Active on
NC Stop
Units
units (MS)
Active on
NC Stop
Units
0.1 %
Active on
NC Stop
Units
0.1 %
Active on
NC Stop
Units
0.1 ms
Active
at once
Units
0.1 ms
6–197