Siemens SINUMERIK 840C Installation Instructions Manual page 141

09.95
Softkey Controller data
Softkey LEC
(5) NC-MD/Spindle
Softkey Basic MD
Softkey Monitoring
limitation
Softkey Speeds
Softkey Measuring
system data
Softkey Controller data
(6) NC-MD/gearbox interpolation
Softkey GI axis
Softkey GI spindle
(7) No explanation here
(8) NC-MD/memory configuration (as from SW 4)
Softkey
DRAM data (SW 4)
Softkey
SRAM data (SW 4)
Softkey Reconfigure
memory (SW 4)

Siemens AG 2001 All Rights Reserved 6FC5197–jAA50
SINUMERIK 840C (IA)
More user manuals on
This softkey contains position controller, compensation, feedforward control, filter
setting and travel to fixed stop machine data. SW 4 also contains quadrant error
compensation (from SW 4.4) machine data.
This softkey contains various leadscrew error compensation machine data.
This softkey contains dimension unit, system clock, setpoint/actual value
assignment, general basic, mixed I/O switchover signals and leading spindle
machine data.
This softkey contains speed range and measuring loop
monitoring machine data.
This softkey contains various speed machine data for the gear stages.
This softkey contains various adaptation actual value 1
measuring data.
This softkey contains position controller, oriented spindle stop M19 and (as from
SW 4.4) feedforward control machine data.
This softkey contains controller parameter following axis, traversing range
following axis and setting gearbox interpolation machine data.
This softkey contains controller parameters following axis, traversing range
following spindle and setting gearbox interpolation machine data.
This softkey contains general configuration, number
of block buffers in block memory and number of measuring value buffer
memories for axis machine data.
This softkey contains various general data II machine
data.
The function "Flexible memory configuration" is introduced with SW 4.
The Reconfig. memory softkey is used to activate a previously set configuration
for which several conditions must be fulfilled (see the section entitled "Functional
Descriptions").
ManualsBase.com
5 Machine Data Dialog (MDD – as from SW 3)
5.2.2 NC machine data
5–13