Siemens SINUMERIK 840C Installation Instructions Manual page 268

04.96
493*
This machine data is only used for the functionality "Electronic gearbox".
With LINK ACTIVE, the positional difference between the following spindle and the leading
axes/spindles can be monitored with the machine data value "Emergency retraction threshold".
The emergency retraction monitoring must be enabled by setting an interface signal.
If the positional difference exceeds this threshold value, it can be output very quickly via a
digital hardware signal. An NC alarm ("Following axis emergency retraction") and the PLC
interface signal EMERGENCY RETRACTION ACTIVE are also set.
The MIXED I/O module must be in use in the servo area to achieve a very fast signal
"Emergency retraction" (in the positional control cycle).
More detailed information is given in the functional description for the electronic gearbox.
Note:
As from SW 4, for 8 gear stages
494*
Every spindle is limited to a maximum acceleration and a maximum speed (NC MD 478* -
485*).
In addition, in both cases the following spindle is checked against a warning threshold. The
warning threshold is defined in this machine data and applies to both the speed threshold and
the acceleration threshold. The warning threshold is entered as a percentage of the maximum
value in question.
If the calculated setpoint speed/setpoint acceleration of the following spindle is greater than the
defined values, the corresponding interface signals are set at the PLC interface.
More detailed information is given in the functional descriptions for the electronic gearbox.
495*
If a fault occurs with the leading axes/spindles, the following spindle goes into follow-up mode,
i.e. traverses with actual values as the control value (see the functional description for the
electronic gearbox, "Maintenance of link during faults"). After the delay shown above, the
following spindle switches from "controlled follow-up" to "normal follow-up" (follow-up mode).
_______
1) As from SW 3
©
Siemens AG 1992 All Rights Reserved
SINUMERIK 840C (IA)
More user manuals on
Emergency retraction threshold
Default value Lower input limit
400
Warning threshold n
Default value Lower input limit
90
Delay controlled follow-up
Default value Lower input limit
16000
ManualsBase.com
6 NC Machine Data (NC MD), NC Setting Data (NC SD)
Upper input limit
16 000
0 99999999 (SW5.4
and higher)
max 1)
and a
max
Upper input limit
0 100
1)
Upper input limit
0 16000
6FC5197- AA50
6.5 Spindle-specific MD (spindle data)
Active on
1)
Reset
Units
1 unit (MS)
Active on
Reset
Units
%
Active on
Reset
Units
1 (ms)
6–83