Siemens SINUMERIK 840C Installation Instructions Manual page 140

5 Machine Data Dialog (MDD – as from SW 3)
5.2.2 NC machine data
Note
(1) NC MD/General NC MD
Softkey General
basic MD
Softkey
Face axis functions
Softkey
Modes
Softkey
Keyswitch
Softkey
Technology MD
Softkey
Computer link
(2) NC-MD/Geometry motion
Softkey
Geometry MD
Softkey Coupled
motion combination
Softkey Coordinate
transformation
Softkey Override
Softkey
Tool offset
(3) NC-MD/Channel
Softkey Basic MD
Softkey
auxiliary functions
Softkey
Multichannel display
Softkey Initial
setting G group
(4) NC-MD/Axis
Softkey Basic MD
Softkey Monitoring
limitation
Softkey
Velocities
Softkey
Measuring system
5–12
More user manuals on
A list of the individual NC machine data is given on the following pages. The
machine data are grouped according to their functions within these areas. The
functions of the individual machine data are described in the section entitled "NC
Machine Data" where they are listed alphanumerically. A number of machine data
depend on the parameter set (see "Selecting a displayed parameter number").
This softkey contains dimension unit, system clock, general
basic and PLC function machine data.
This softkey contains various face axis function machine data.
This softkey contains various operating mode machine data.
This softkey contains various keyswitch machine data for
defining the input disable.
This softkey contains function activation, thread, programming,
position signal, mixed I/O and KISP machine data.
This softkey contains different computer link machine data.
This softkey contains various geometry machine data.
This softkey contains various coupled motion combination
machine data.
This softkey contains various coordinate transformation
machine data.
This softkey contains feedrate override and spindle override machine data.
This softkey contains various tool offset machine data.
This softkey contains various channel basic machine data.
This softkey contains output auxiliary function, fast auxiliary
function and block search machine data.
This softkey contains axis assignment and spindle assignment
multichannel display machine data.
This softkey contains initial setting machine data for various
G groups.
This softkey contains units of measurement, system clock, setpoint/actual value
assignment, general basic, face axis, rotary axis, indexing axis, mixed I/O
switchover signal and leading axis machine data.
This softkey contains referencing, software limit switch, general
monitoring and measuring loop machine data.
This softkey contains various velocity machine data.
This softkey contains adaptation actual value 1/actual value 2
and encoder/absolute encoder machine data.
ManualsBase.com

Siemens AG 2001 All Rights Reserved 6FC5197–jAA50
09.95
SINUMERIK 840C (IA)