Siemens SINUMERIK 840C Installation Instructions Manual page 850

09.95
12.11.1.3 Synchronizing the absolute encoder with the machine
After installation or after replacing the absolute encoder, the measuring system must be
synchronized with the machine system in the same way as with any incremental system. The
absolute encoder is set up with the following NC machine data.
• Axial machine data:
NC MD 240*
NC MD 396*
• Machine data bits:
NC MD 1808* bit 0 = 1
Definition of terms:
Same direction:
Opposite direction:
Direct measuring system:
Indirect measuring system:
There are two synchronization methods; these are explained below.
•
Synchronization in "Reference point approach" mode
Like any standard encoder, the SIPOS absolute encoder has A and B tracks and a zero
pulse.
Similar to the incremental system, the encoder is synchronized with the machine system
by combining the zero mark of the encoder with the reference point cam signal.
A distinction can be made between two cases by setting NC MD 1808* bit 0 = 1 ("Axis
with SIPOS absolute encoder") during reference approach.
© Siemens AG 1992 All Rights Reserved
SINUMERIK 840C (IA)
More user manuals on
absolute system
reference point value
absolute offset
axis with SIPOS absolute encoder
bit 2 = 0 absolute encoder same direction as the
machine system
1 absolute encoder opposite direction to
machine system
bit 3 = 0 absolute offset not valid
bit 3 = 1 absolute offset valid
The absolute encoder value rises and falls with the machine
absolute value.
The absolute encoder value rises as the machine absolute
value falls and vice versa.
The absolute encoder is a position measuring system (e.g.
linear scale) and is connected directly to the mechanical
section.
The absolute encoder is used to measure position and speed
and is therefore connected to the motor.
ManualsBase.com
12.11.1 SIPOS absolute encoder up to SW 4
6FC5197- AA50
12 Functional Descriptions
12–75