Siemens SINUMERIK 840C Installation Instructions Manual page 444

10.94
210
Input of address for the variable which is significant for stopping the recording (see also
MD 206).
211
Input of threshold (value) with which the contents of the variable specified in MD 210 are
compared in order to stop the recording (see also MD 206).
212
Input of address of recording signal 1 (see also MD 206).
213
Input of address of recording signal 2 (see also MD 206).
214
Input of start for the output of the transient recorder function (see also MD 206).
The contents of the recorder memory are output via 2 DACs as soon as the above machine
data is set to 1H. The output is repeated cyclically.
215
Input of shift factor for signal 1 (see also MD 206). The top 8 bits from a 16-bit wide memory
location are output. This machine data specifies how often the value must be shifted to the left
beforehand.
©
Siemens AG 1992 All Rights Reserved
SINUMERIK 840C (IA)
More user manuals on
Address for stop condition
Default value Lower input limit
0000 0000
Threshold for stop condition
Default value Lower input limit
0000 0000
Default value Lower input limit
0C00 0000
Default value Lower input limit
0C04 0000
Default value Lower input limit
0000 0000
Default value Lower input limit
0
ManualsBase.com
7 Drive Machine Data (SIMODRIVE Drive MD)
Upper input limit
FFFF
Upper input limit
FFFF
Address for signal 1
Upper input limit
FFFF
Address for signal 2
Upper input limit
FFFF
Start output of recording
Upper input limit
0001
Shift factor signal 1
Upper input limit
0 15
6FC5197- AA50
7.1.2 MSD MD (data description - SW 3)
Active
at once
Units
Hex
Active
at once
Units
Hex
Active
at once
Units
Hex
Active
at once
Units
Hex
Active
at once
Units
Hex
Active
at once
Units
–
7–29