Siemens SINUMERIK 840C Installation Instructions Manual page 399

6 NC Machine Data (NC MD), NC Setting Data (NC SD)
6.10 MDs for flexible memory configuration
60011
Default value
0
Machine data reserved by the system.
60012
Default value
0
This machine data is used simply to indicate the CPU loading. For a description, refer to the
section entited "Installation of axis and spindle".
60013
Default value
15
This MD is used to define the memory for real axes (> 15). If the user has defined more real
axes than memory is available, alarm 71 is displayed.
60014
Default value
0
Memory for drive software MSD/FDD 0/2/3/4/6 blocks of 96 Kbytes each, see also machine
data 60003 and 60004.
6100*
Default value
23
This MD is used to define channel-specifically the maximum number of part program blocks
that can be predecoded during execution.
See "Flexible memory configuration" functional description.
6–214
More user manuals on
Memory configuration of NC module as from SW 4
Lower input limit
Load cap. of NC CPU (as from SW 5)
Lower input limit
-
Memory for real axes (as from SW 5)
Lower input limit
15
Number of memory blocks for drive software
(as from SW 6)
Lower input limit
0
Channel 1 to channel 6 as from SW 4
Lower input limit
0
ManualsBase.com
Upper input limit
Upper input limit
100
Upper input limit
30
Upper input limit
6
Upper input limit
3 450
©
Siemens AG 1992 All Rights Reserved
07.97
Active
after SK
"Reconfigure
memory"
Units
Byte
Active
At once
Units
%
Active
Power On
Units
approx. 16 KB/axis
Active
Power On
Units
96 Kbytes
Active
after SK
"Reconfigure
memory"
Units
1 block buffer
6FC5197- AA50
SINUMERIK 840C (IA)