Mitsubishi Electric MELSEC iQ-R Series User Manual page 534

[Cd.33] Simultaneous starting axis start data No.3
Use this data item to specify a start data No.3 for each axis that starts simultaneously.
For 2 axis simultaneous starting and 3 axis simultaneous starting, the axis setting is not required. (Setting
value is ignored.)
Fetch cycle: At start
■Setting range
• Set with a decimal.
Setting range of [Cd.33]
1 to 600
■Buffer memory address
Refer to the following for the buffer memory address in this area.
Page 402 Axis control data
■Default value
Set to "0".
[Cd.34] Step mode
To perform a step operation, use this data item to specify the units by which the stepping should be performed.
Fetch cycle: At start
■Setting value
• Set with a decimal.
Setting value
0
1
■Buffer memory address
Refer to the following for the buffer memory address in this area.
Page 402 Axis control data
■Default value
Set to "0".
[Cd.35] Step valid flag
This data item validates or invalidates step operations.
Fetch cycle: At start
■Setting value
• Set with a decimal.
Setting value
0
1
■Buffer memory address
Refer to the following for the buffer memory address in this area.
Page 402 Axis control data
■Default value
Set to "0".
12 DATA USED FOR POSITIONING CONTROL
532
12.8 Control Data
Downloaded from ManualsNet.com search engine
Details
Stepping by deceleration units
Stepping by data No. units
Details
Invalidates step operations
Validates step operations