[Md.114] Servo alarm
• When a servo amplifier alarm/warning occurs, the alarm/warning No. is stored.
• When "[Cd.5] Axis error reset" is set to "1" after removing the cause of an alarm/warning on the servo amplifier side, the
servo alarm is cleared (set to "0").
Ex.
For MR-J5(W)-G
When the servo alarm [AL35.1 Command frequency error] occurs on the drive unit, "0035H" is stored.
LED display of
MR-J5(W)-G
Monitor
0
value
Refresh cycle: Immediate
■Buffer memory address
Refer to the following for the buffer memory address in this area.
Page 401 Axis monitor data
[Md.115] Servo alarm detail number
• When a servo amplifier alarm/warning occurs, the alarm/warning No. is stored.
• When "[Cd.5] Axis error reset" is set to "1" after removing the cause of an alarm/warning on the servo amplifier side, the
servo alarm detail number is cleared (set to 0).
Ex.
For MR-J5(W)-G
When the servo alarm [AL35.1 Command frequency error] occurs on the drive unit, "0001H" is stored.
LED display of
MR-J5(W)-G
Monitor
0
value
Refresh cycle: Immediate
■Buffer memory address
Refer to the following for the buffer memory address in this area.
Page 401 Axis monitor data
12 DATA USED FOR POSITIONING CONTROL
506
12.7 Monitor Data
Downloaded from
ManualsNet.com
Alarm No. display
Alarm details display
.
0
3
5
0
3
5
0
Servo alarm
Servo alarm detail information
Alarm No. display
Alarm details display
.
0
3
5
0
3
5
0
Servo alarm
Servo alarm detail information
search engine
.
1
0
0
1
.
1
0
0
1