Acceptance Test Support - Siemens SINUMERIK 840D sl Function Manual

10.6.3

Acceptance test support

In order to make it easier to carry out the acceptance test and standardize this, there is the
function "Acceptance test support" in the SinuCom NC commissioning tool".
The objective of this acceptance support is to control the creation and administration of an
acceptance report and prepare and carry out the required test steps using the appropriate
operator actions via the operator interface. The test steps required as part of the acceptance
test are not completely executed automatically but are controlled by a skilled operator. This
operator must perform the measures associated with the test step on the system being tested.
The acceptance test support provides the following:
● Support for documenting the active monitoring functions and monitoring limit values by
exporting the appropriate machine data.
● Support for documenting the checksum values.
● Standardization of the procedure when performing the test using a pre-defined checklist.
● The time and resources required for testing are reduced by preparing test procedures within
the system, automatic trace and evaluation techniques and it takes less time to
acknowledge SI alarms that are output.
Software requirements
The acceptance test support function is based on the interaction between the NCK/drive and
the SinuCom NC user interface. This means the use of this function requires that these
components must have a certain minimum software version.
SinuCom NC software Version 7.2 SP1
NCU system software version 1.3
The basic functionality of the SinuCom NC software is explained within the scope of its own
documentation. This documentation also provides information about the steps when handling
the acceptance test support function, a description of the screen forms and the menu
prompting. This is the reason that this is not handled in this documentation.
References: Commissioning/Service Tool SINUMERIK SinuCom NC (INC)
Scope of the test list
The test steps of the SI acceptance test, supported by the system, is based on the previous
test execution and comprises the following steps:
Designation
General
Overview
Checking the forced checking procedure
Switch-off signal paths
External stops
Qualitative function checks
Safety Integrated
Function Manual, 12/2017, 6FC5397-4BP40-6BA1
Purpose of the test step
Document the machine details (e.g. manufacturer, machine type,...)
Test the forced checking procedure of the switch-off signal paths for the NCK and
drive. (logging NCK Alarm 27002 is sufficient.)
Test the forced checking procedure of the external stop responses (that are being
used).
Commissioning
10.6 Acceptance test
553