Siemens SINUMERIK 840D sl Function Manual page 739

A30640 (F) SI P2: Fault in the switch-off signal path of the second channel
Remedy For a higher-level control, the following applies:
● Check the PROFIsafe address in the higher-level control and Motor Module and if required, correct
● Save all parameters (p0977 = 1).
● Carry out a POWER ON for all components.
In general, the following applies:
Upgrade the Motor Module software.
Response for NO (OFF2)
F
Acknowledg‐ IMMEDIATELY (POWER ON)
ment for F
F30649 SI P2: Internal software error
Response OFF2
Acknowledg‐ IMMEDIATELY (POWER ON)
ment
Explanation An internal error in the Safety Integrated software in monitoring channel 2 has occurred.
Note:
This fault results in a STOP A that cannot be acknowledged.
Fault value (r0949, interpret as hexadecimal):
Only for internal Siemens troubleshooting.
Remedy Carry out a POWER ON (power off/on) for all components.
● Re-commission the Safety Integrated function and carry out a POWER ON.
● Upgrade the Motor Module/Hydraulic Module software.
● Contact the Hotline.
● Replace the Motor Module/Hydraulic Module.
F30650 SI P2: Acceptance test required
Response OFF2
Acknowledg‐ IMMEDIATELY (POWER ON)
ment
Safety Integrated
Function Manual, 12/2017, 6FC5397-4BP40-6BA1
11.3 Safety messages for SINAMICS S120
Diagnostics
739