Siemens SINUMERIK 840D sl Function Manual page 679

27254 PROFIsafe: F-module %1, error on channel %2; %3<ALSI>
Parameter %1 = PROFIsafe address or name
%2 = channel type, channel number
%3 = supplementary info, system variables - field index
Explanation The F-module signals that an error has occurred in the interface of the specified channel. The alarm is only
triggered for ET200 F-modules. The type of channel (input or output channel) is displayed in %2 using the
IN and OUT abbreviation).
Using parameter %3, a specific alarm message can be configured on the HMI for each of the listed system
variables
● 1....64: Error in system variables $A_INSE[1...64]
● 65...128: Error in system variables $A_OUTSE[1...64]
● 321...448: Error in system variables $A_INSE[65..192]
● 449...576: Error in system variables $A_OUTSE[65..192]
● -1: Error in the input or output channel for which there is no SPL assignment assignment.
Response Mode group not ready
NC start disable in this channel
Interface signals are set
Alarm display
NC stop for alarm
A STOP D/E is initiated (this can be set using MD10097 $MN_SAFE_SPL_STOP_MODE) on all axes with
safety functionality.
Remedy Check the wiring. Wiring OK: Replace the F-module.
Program con‐ Remove the error and press RESET.
tinuation
27255 PROFIsafe: F-module %1, general error
Parameter %1 = PROFIsafe address or name
Explanation The specified PROFIsafe module signals an error: More detailed information on the cause of the error cannot
be made without further resources.
This alarm is initiated for all types of PROFIsafe slaves.
Response Mode group not ready
Channel not ready
NC start disable in this channel
Interface signals are set
Alarm display
NC stop for alarm
A STOP D/E is initiated (this can be set using MD10097 $MN_SAFE_SPL_STOP_MODE) on all axes with
safety functionality.
Remedy Check the wiring
Program con‐ Remove the error and press RESET.
tinuation
Safety Integrated
Function Manual, 12/2017, 6FC5397-4BP40-6BA1
11.2 NCK safety alarms for SINUMERIK 840D sl
Diagnostics
679