Siemens SINUMERIK 840D sl Function Manual page 673

27223 PROFIsafe: NCK F-module MD %1[%2] is not a %3 module
Parameter %1 = MD name
%2 = MD field index
%3 = module type
Explanation The F-module parameterized in the specified NCK MD has not been designated as an appropriate input/
output module in the S7 PROFIBUS configuration.
● %3 = INPUT: NCK F-parameterization expects an INPUT module
● %3 = OUTPUT: NCK F-parameterization expects an OUTPUT module
● %3 = IN/OUT: NCK F-parameterization expects an INPUT/OUTPUT module
Response Mode group not ready
Channel not ready
NC start disable in this channel
Interface signals are set
Alarm display
NC stop for alarm
Remedy Check the module in the S7 PROFIBUS configuration
Program con‐ Switch control system OFF and ON again.
tinuation
27224 PROFIsafe: F-module MD %1[%2] – MD %3[%4]: Double assignment PROFIsafe address
Parameter %1 = MD name 1
%2 = MD field index 1
%3 = MD name 2
%4 = MD field index 2
Explanation In the NCK MD or in the S7 F-parameters, the same PROFIsafe address has been parameterized for the F-
modules parameterized in the specific machine data. This means that a clear communications relationship
between the F-master and F-slave is not possible.
Response Mode group not ready
Channel not ready
NC start disable in this channel
Interface signals are set
Alarm display
NC stop for alarm
Remedy Check and correct the S7 F-parameterization and NCK-MD.
Program con‐ Switch control system OFF and ON again.
tinuation
27225 PROFIsafe: Slave %1, configuration error, %2
Parameter %1 = PROFIBUS slave address
%2 = configuration error
Explanation An error has occurred during the evaluation of the S7 PROFIBUS configuration for the specific slave. This is
further specified in alarm parameter %2.
%2 = PRM header: The PRM telegram for this slave could not be clearly interpreted (is currently not initiated).
Safety Integrated
Function Manual, 12/2017, 6FC5397-4BP40-6BA1
11.2 NCK safety alarms for SINUMERIK 840D sl
Diagnostics
673