Setting Group - GE F650 Instruction Manual

5.5 CONTROL ELEMENTS
5.5CONTROL ELEMENTS
The F650 incorporates the following control elements:

Setting Group

Underfrequency
Overfrequency
Synchrocheck (25)
Autoreclose (79)
Breaker Failure (50BF)
VT Fuse Failure
Broken Conductor (I2/I1)
Locked Rotor
Pulse Counters
Analog Comparators
Frequency Rate of Change (81 df/dt)
Load Encroachment
Note: for all control elements related to the breaker, it must be considered that all operations will be performed considering
the status of the switchgear configured as breaker. In Setpoint > Relay Configuration > Switchgear up to 16 switchgear
elements can be configured to operate and be monitored, but only one of them can be configured as a breaker, for
monitoring, number of openings and closings counters, (KI)
5
The settings used for setting table management are located in Setpoint > Control Elements > Setting Group:
Table 5–73: SETTING GROUP SETTINGS
SETPOINT > CONTROL ELEMENTS > SETTING GROUP
SETTING DESCRIPTION
Setting Grouping Permission
Active Group
Snapshot Event generation
The snapshot event setting enables or disables the snapshot event generation for this element.
For more detailed information go to section 5.4.1
5-86
2
t.
NAME DEFAULT
VALUE
Function DISABLED
Active Group GROUP 1
Snapshot Events ENABLED
F650 Digital Bay Controller
5.5.1 SETTING GROUP
STEP RANGE
N/A [DISABLED – ENABLED]
N/A [GROUP 1 – GROUP 2 – GROUP 3]
N/A [DISABLED – ENABLED]
5 SETTINGS
GEK-106310AB