Protection Elements - GE F650 Instruction Manual

Digital bay controller

Hide thumbs Also See for F650:

Table of Contents

5.9 RELAY CONFIGURATION

This tab allows assigning operands (logic signals) as inputs to different protection elements. This way, the user assigns

which operands can reset the Thermal Image, etc. In this screen we can also configure a logic signal to perform the LED

reset by communications.

The settings are as follows:

Select checkbox enables/disables the selection.

Source setting defines the operand that performs the function indicated in the SELECT column. NOT setting inverts

the block signal.

NOT setting for inverting the logic signal.

OR checkbox to select a group of operands instead of a single one. The relay performs an OR of the signals, and its

output produces the operation.

The following figure shows this screen:

Figure 5–49: PROTECTION ELEMENTS

F650 Digital Bay Controller

5.9.4 PROTECTION ELEMENTS

GEK-106310AB