GE F650 Instruction Manual page 100

4 HUMAN INTERFACES. SETTINGS & ACTUAL VALUES 4.1 ENERVISTA 650 SETUP SOFTWARE INTERFACE
Data Logger
Demand
Energy
Breaker Maintenance
4.1.9.3 METERING
The Metering menu includes all the measurements available in the device. Primary and secondary values, and also the
data related to the recording functions in the relay.
Table 4.20: GENERAL OVERVIEW OF METERING MENU:
METERING
Primary Values
Secondary Values
Phasor Diagram
Frequency
4.1.9.4 INPUTS/OUTPUTS
The Inputs/Outputs menu includes all the inputs and outputs signals available in the device. Contact and virtual type.
Table 4.21: GENERAL OVERVIEW OF INPUTS/OUTPUTS MENU:
INPUTS/
OUTPUTS
Contact Inputs
Contact Output Status
Contact Outputs
Operates
Contact Outputs
Resets
IO Board Status
Virtual Inputs
Virtual Outputs
Remote Outputs
Remote Inputs
Analog Inputs (*)
Virtual Output Latched
Options enabled only in On-line mode are marked as (*). Options enabled only in Off-line mode are marked as (**)
GEK-106310AB
Data logger information about oldest and newest sample time stamp,
and number of channels and days configured in data logger settings.
Demand trigger and reset inputs status.
Freeze, unfreeze and reset input signals for energy counters.
All signals related to breaker maintenance, such as number of openings,
2
closings, (KI) t counters, alarm signal for (KI)
Primary values measurements for currents, voltages, power, energy and
demand
Secondary values measurements for currents, voltages and power.
Current, voltage and sequence components.
Line and Bus frequencies.
Status of digital inputs in the Relay for each board according to the relay
model.
Status of digital outputs in the Relay for each board according to the relay
model.
Status (activated or not) of the variables used to operate a contact
output. To configure these
Configuration>Outputs" menu.
Status (activated or not) of the variables used to reset a contact output.
To configure these signals go to "Setpoint>Relay Configuration>Outputs"
menu. This output reset Command will only be effective if the "latch"
option has been Selected for the "Output Type" setting on the I/O board,
thus when the contact output has been configured to emulate function 86
(latching relay).
Status of I/O boards. This status provides if the hardware it is OK (boards
matching relay model, correctly inserted in their tracks, in good state and
communicating through the internal CAN Bus).
Status of Virtual inputs latched (32) and self-reset (32).
Status of virtual outputs (configured in PLC Editor). Up to 512.
States of remote outputs for IEC61850 models.
Status of remote device and remote inputs for IEC61850 models.
Measurements coming from analog inputs (DCMA)
Status of Virtual Output Latched (configured in PLC Editor). Up to 16.
F650 Digital Bay Controller
2
t, etc.
signals go to "Setpoint>Relay
4
4-27