GE F650 Instruction Manual page 437

Digital bay controller

Hide thumbs Also See for F650:

Table of Contents

7.3 IEC 61850 CONFIGURATOR

CONFIGURATION OF CONTROLLABLE OBJECTS

In the F650 relay IEC 61850 controllable data exist in logical nodes vinGGIO, XCBR and CSWI. Data from Logical node

vinGGIO maps to Virtual Inputs of F650. XCBR represents the circuit breaker and all four CSWI logical nodes represent

four first switchgear of F650 relay.

Controllable data in vinGGIO logical node are SPCSO1 - SPCSO64 and DPCSO1 - DPCSO16. Signals SPCSO1 -

SPCSO32 map to 32 Virtual Inputs Latched in F650 relay and signals SPCSO33 - SPCSO64 map to Virtual Inputs Self-

Reset. DPCSO1 - DPCSO16 are double control points and operate on pairs of Virtual Inputs Latched. Thus DPCSO1 -

DPCSO16 map to 32 Virtual Inputs Latched and an operation of one attribute DPCSO always operate on two Virtual Inputs

Latched, one Virtual Input of the pair is set to "1" and the other Virtual Input of the pair is set to "0".

Controllable data in XCBR and CSWI logical nodes are Pos (position) objects. These are operations used to change state

of breaker or switch.

F650 relay supports all four IEC 61850 control modes (ctlModel), which are:

Direct control with normal security

SBO control with normal security

Direct control with enhanced security

SBO control with enhanced security

However for data in vinGGIO logical node only "direct control with normal security" mode of control can be used.

There is a configurable timeout for SBO control modes in XCBR and CSWI logical nodes. The value range for SBO timeout

is 500 ms - 60 seconds. The sboClass attribute can only have value "operate-once", "operate-many" pattern is not

supported in IEC 61850 SBO controls in 650 relay.

Figure 7–13: CONFIGURATION OF CONTROL MODEL (CTLMODEL) OF POS DATA OBJECT IN XCBR LOGICAL

F650 Digital Bay Controller

7 IEC 61850 PROTOCOL

GEK-106310AB