GE F650 Instruction Manual page 535

A.1 LOGIC OPERANDS
A
Other internal states
Autocheck Internal States (Not available)
Note: It is advisable to use the critical alarms to raise an event or to light a warning led for maintenance purposes. See the
example below, the Board X Status depends on the relay model.
A-2
USER MAP STATUS
FACTORY
CALIBRATION
FLEXCURVE A STATUS User curve A: (0) Not configured (1) Configured
FLEXCURVE B STATUS User curve B: (0) Not configured (1) Configured
FLEXCURVE C STATUS User curve C: (0) Not configured (1) Configured
FLEXCURVE D STATUS User curve D: (0) Not configured (1) Configured
Green Zone
Yellow Zone
Orange Zone
Red Zone
UpTime
TIMER STATUS
GRAPHIC STATUS
ALARM TEXT ARRAY
Figure A–1: PROTECTION ALARM SIGNAL
F650 Digital Bay Controller
User map status: (0) Not configured ; (1) Configured
Calibration status (0) Relay calibrated; (1) Not calibrated
Memory internal status
Memory internal status
Memory internal status
Memory internal status
System Time
Real time clock autocheck (not available)
Graphic display status (not available)
Text display status (not available)
APPENDIX A
GEK-106310AB