Communication Menu Overview - GE F650 Instruction Manual

4 HUMAN INTERFACES. SETTINGS & ACTUAL VALUES 4.1 ENERVISTA 650 SETUP SOFTWARE INTERFACE
The communication menu includes the computer screen to start communicating with the relay, the different update
procedures available in device: firmware, operative system, web server and other file storing capabilities (upload and
download info files to/from relay).
For more detail information go to section 4.1.4 for communication menus description and to section 5 for flash memory
update procedures.
Table 4.24: GENERAL OVERVIEW OF COMMUNICATION MENU:
COMMUNICATION
Computer
Modem (**)
Troubleshooting (*)
Calibration (*)
Upgrade firmware
version (**)
Upgrade operating
system (**)
Upgrade 650 web
server
Upload info files to
relay
Download info files
from relay
Options enabled only in On-line mode are marked as (*). Options enabled only in Off-line mode are marked as (**)
The rest of options available in the Communication menu in EnerVista 650 Setup are:
- Modem: Allows configuring the unit for remote communications via modem, using telephonic line. It is only available if
the relay is not communicating and if modem has been select on Communication>computer control type selection. Go
to "Communication>Modem"
- Troubleshooting (Serial or Ethernet connection): Lets the user to perform reading or writing in ModBus addresses, for
verifying communications and access to different positions in the ModBus memory map. Only available if the
communication has already been established. Go to "Communication>Troubleshooting". An example is provided in
Figure 4–14:
GEK-106310AB
Menu to start communication with the relay.
Menu to set modem communication parameters (only available if control
type is set to modem in computer menu).
Menu that Lets the user to perform reading or writing in ModBus
addresses, for verifying communications and access to different
positions in the ModBus memory map.
Retrieval and store calibration settings from/to relay.
Menu to update the relay firmware version through Ethernet
Menu to update the relay boot code (front RS232 and Ethernet
connection)
Menu to update the web server application (if available)
Hard disk storage of settings and configuration files on the relay.Option
only performed through Ethernet, not available in C650 models.
Retrieval of settings and configuration files that had been previously
stored in the relay hard disk.Option only performed through Ethernet, not
available in C650 models.
F650 Digital Bay Controller

4.1.11 COMMUNICATION MENU OVERVIEW

4
4-29