GE F650 Instruction Manual page 476

Digital bay controller

Hide thumbs Also See for F650:

Table of Contents

9 BOOTCODE AND FIRMWARE UPGRADE

In firmware version previous to 1.70 the Enervista 650 Setup program requires the IP address of the relay under

upgraded and its serial number.

In versions 1.70 and higher it is also necessary to enter the ordering code for the relay. See Figure 9–23:

If the relay under is not a enhanced model or control functionality then click the Upgrade Firmware button to continue

the process (Figure 9–24:) Then the process will continue as per step 9.3.2.4 forward.

GEK-106310AB

Figure 9–23: RELAY SERIAL NUMBER

F650 Digital Bay Controller

9.3 FIRMWARE VERSION UPGRADE