Symptoms And Recommended Actions - GE F650 Instruction Manual

13 F650 TROUBLESHOOTING GUIDE
13 F650 TROUBLESHOOTING GUIDE 13.1SYMPTOMS AND RECOMMENDED ACTIONS
F650 units have been designed and verified using the most advanced and reliable equipment. Mounting and
testing automation ensure a high consistency of the final product. Before sending a unit back to the factory, we
strongly recommend you follow the recommendations below. Even if it will not always solve the problem, at least
they will help define it better for a quicker repair.
If you need to send a unit back to the factory for repair, please use the appropriate RETURN MATERIAL AUTHORIZATION
process, and follow the shipping instructions provided by our Service Department, especially in the case of international
shipments. This will lead to a faster and efficient solution of your problem.
CATEGORY SYMPTOM
Protection The relay does not trip -Function not permitted
General When feeding the unit,
no indicator is lit up
Communication The relay does not
communicate via the
front RS232 port
General After
firmware
does not start up and
always
message
Loading...".
GEK-106310AB
POSSIBLE CAUSE
- Function blocked
- Output not assigned
- The unit is not set to ready
-Insufficient power supply
- Wrong versions
-Fuse failure
- Loose fuse
-Incorrect wiring
-Incorrect cable
-Damaged cable
-Relay or PC not grounded
-Incorrect baudrate, port, address, etc.
Updating the Check that the bootware version
the relay match with the firmware version
shows the
"Os
F650 Digital Bay Controller

13.1 SYMPTOMS AND RECOMMENDED ACTIONS

RECOMMENDED ACTION
-Set the function
ENABLED
-Check Protection units block screen
-Program the output to the desired
function using ENERVISTA 650 Setup
logic configuration
- Verify that the general setting is set to
disable and the out of service state is
not active
-Verify the voltage level using a
multimeter in
terminals, and check that it is within
the model range
-Check relay and ENERVISTA 650
Setup versions are the same
-Remove power supply, dismount the
power supply module and replace the
fuse
-Same as above with same fuse
-Make sure that terminals labeled +
and – are connected to the 9-pin
connector corresponding to the power
source
-Make sure you are using a straight
cable
-Replace the cable
-Ensure ground connection
-Test other ports, other baudrates, etc.
Make sure that the communication
parameters in the computer match the
ones in the relay.
-If there is an incompatibility between
boot and firmware version, update to
the corresponding boot and after that
update the firmware version
-If the boot and firmware versions are
correct, perform the firmware update
procedure again.
permission to
13
the power supply
13-1