Accessories; Communication Modules; Remote Control Panel (Rcp); Finger Guard Kit - GE ASTAT XL User Manual

12

Accessories

12.1

Communication Modules

ASTAT XL soft starters support network communication via easy-to-install communications modules.
Each soft starter can support one communications module at a time.
Available protocols:
Ethernet (Profinet, Modbus TCP, Ethernet IP), Profibus, DeviceNet, Modbus RTU, and USB.
12.2

Remote Control Panel (RCP)

A remote mounted keypad can be installed with the ASTAT XL. The keypad can be mounted up to 3
metres away from the starter, for control and monitoring.
The starter can be controlled and programmed from either the remote keypad or the keypad on the
starter. Both displays show the same information.
The remote keypad also allows parameter settings to be copied between soft starters.
12.3

Finger Guard Kit

Finger guards may be specified for personnel safety. Finger guards fit over the soft starter terminals
to prevent accidental contact with live terminals. Finger guards provide IP20 protection when
correctly installed.
NOTE
Finger guards are required for models QLxxB0145D~QLxxB0425D to be UL compliant. See UL
Compliant Installation on page 14 for more information.
NOTE
Finger guards can be used on soft starter models QLxxB0145D~QLxxB1000D (internally
bypassed models only).
12.4

PC Software

GE ASTAT Setup Tool ed.3 PC software provides monitoring, programming and control of up to 99 soft
starters.
A Modbus or USB communication module is required for each starter to use GE ASTAT Setup Tool ed.3.
ASTAT XL User Manual
Different kits are required for different models.
DET-812
Fout! Stijl niet gedefinieerd.
73