Honeywell FMZ Series Pilot's Manual page 473

Flight Management System (FMS) for the Agusta AW139/AB139 Helicopter
Message
CHECK ATT/HDG
CONFIG
CHECK BARO SET
CHECK DATA LOAD
(xx)
CHECK DEST FUEL
CHECK DMU
CHECK GPS
CONFIG
CHECK GPS
POSITION
CHECK GPS 1
POSITION
CHECK GPS 2
POSITION
CHECK GPS 3
POSITION
A28- - 1146- - 181
REV 3 Mar 2009
Honeywell International Inc. Do not copy without express permission of Honeywell.
Table 11- -1 (cont)
FMS Messages
Type
ALERTING More than one input port has
been configured with the
same ASCB ATT/HDG
sensor number.
ALERTING The aircraft has passed the
transition altitude by more
than 1000 feet or is leveling
and the baro set has not
been adjusted to the proper
value. This message is
shown during climbs and
descents.
ADVISORY The attempted data loader
operation has failed. The
failure reason is indicated by
the value xx. Refer to
Maintenance, Section 12 for
decoding xx value.
ALERTING The destination fuel equals
zero.
ALERTING The FMS has been waiting
for a flight plan from the
DMU for over 60 seconds.
ALERTING More than one input port has
been configured with the
same GPS sensor number
OR multiple GPS are
configured and one of the
sensors has an SDI of 0.
ALERTING The position from the
identified GPS sensor is
more than 10 nautical miles
(NM) from the FMS position.
Definition
Messages
11-3