Honeywell FMZ Series Pilot's Manual page 171

Flight Management System (FMS) for the Agusta AW139/AB139 Helicopter
Step Procedure 6- -4 Stored Waypoints Option One
3 The PILOT WAYPOINT page is displayed, shown in
Figure 6--11. DAISY is defined by one the following three
ways: step 4 (LAT/LON), 6 (P/B/D), or 8 (P/B/P/B).
When a previously used identifier is entered, the definition
for the waypoint is displayed. This prevents the duplication
of waypoint names.
A page similar to Figure 6--11 is displayed when an
undefined waypoint is entered on any page that accepts
waypoint entries (except the position initialization (POS
INIT) page). For these cases, the RETURN prompt is
displayed at 1R. The RETURN prompt is used before or
after a waypoint is defined. The RETURN prompt is used
to return to the page where the undefined waypoint was
entered. When the waypoint is not defined, the waypoint
entry remains in the scratchpad. When the waypoint is
defined, the waypoint entry is completed. By selecting 5R
the pilot loads the global positioning system (GPS) position
as the LAT/LON coordinates of the pilot--defined waypoint.
4 Enter latitude/longitude and select to 2L.
N3320.77W11152.58 is used in this example.
A28- - 1146- - 181
REV 3 Mar 2009
Honeywell International Inc. Do not copy without express permission of Honeywell.
Figure 6- -11
PILOT WAYPOINT 1/1
Navigation
6-13