Honeywell FMZ Series Pilot's Manual page 150

Flight Management System (FMS) for the Agusta AW139/AB139 Helicopter
3R -- The runway/helipad elevation from the database is displayed
D
in small characters, except when entered by the pilot. The elevation
is displayed in the following priority order:
— Pilot--entered value (large characters)
— Calculated from entered pressure altitude
— Database runway/helipad elevation
— Sensed baro altitude
— Calculated from sensed pressure altitude
— Prompts.
The pilot enters elevation or pressure altitude. When an entry is
made, the value not entered is calculated from the entered value.
For example, when the pilot enters an elevation, the pressure
altitude is calculated. When the pressure altitude is entered, the
elevation is calculated. When baro set is entered, the parameter
being calculated is recalculated. Entry of *DELETE* removes any
pilot entry and the highest priority value is displayed.
5R -- Selection of this line accesses the DEPARTURE SURFACES
D
page.
6L -- Access to the PERF DATA page is on this line.
D
The calculated data for a runway when a runway is selected as a
departure surface is displayed on the TAKEOFF 2/2 page, shown in
Figure 5--17. The TAKEOFF 2/2 page is displayed by pushing the NEXT
function key when the TAKEOFF 1/2 page is displayed.
Performance
5-30
Honeywell International Inc. Do not copy without express permission of Honeywell.
A28- - 1146- - 181
REV 3 Mar 2009