Table of Contents
Advertisement
Flight Management System (FMS) for the Agusta AW139/AB139 Helicopter
Step
Procedure 6- -34 Flight Configuration Setup
3
Set the BANK FACTOR. Enter desired bank factor into the
scratchpad and line select 1L. The BANK FACTOR entry is
used to set bank limits. The default BANK FACTOR is 15
and any number from 0 to 15 is able to be entered.
DETAILS -- The BANK FACTOR is the highest bank angle
to be used by the FMS unless a higher angle is needed to
maintain protected airspace. The FMS incorporates a
model of the protected airspace that includes the tighter
restrictions at low altitudes and approach. The FMS
checks each turn against the model and increases the
bank angle above the entered BANK FACTOR, when
required.
The BANK FACTOR is entered at any time but only on the
master MCDU when operating in synchronous mode.
When the FMS configuration changes from single,
independent, or initiated transfer to synchronous mode, the
master bank factor overwrites the slave bank factor value.
4
Set FPL AUTO PAGE to ON or OFF at line select 2R. The
FPL AUTO PAGE feature applies when building both
active and stored flight plans.
DETAILS
FPL AUTO PAGE ON -- The FMS automatically
D
advances the flight plan page, after a slight delay, when
the fifth waypoint is entered on any given page. FPL
AUTO PAGE continues until the destination is entered
as a waypoint on the left side of the page.
When an airway is entered, the FPL AUTO PAGE does not
advance the pages.
FPL AUTO PAGE OFF -- All flight plan page changes
D
are done using the NEXT and PREV keys.
A28- - 1146- - 181
REV 3 Mar 2009
Honeywell International Inc. Do not copy without express permission of Honeywell.
Navigation
6-187
Advertisement
Table of Contents
