Cisco Catalyst 4500 Series Configuration Manual page 1191

Chapter 2
transport udp (netflow-lite exporter submode)
NetFlow-lite is only supported on the Catalyst 4948E and Catalyst 4948E-F Ethernet switches.
Note
To specify a UDP transport destination port for a NetFlow-lite collector, use the transport udp
command. To delete a transport UDP, use the no form of this command.
Syntax Description
destination-port
Command Default None
Command Modes netflow-lite exporter submode
Command History Release
15.0(2)SG
Usage Guidelines One of the mandatory parameters for a minimally configured exporter along with the destination address
and UDP destination port of the NetFlow-lite collector.
Examples The following example shows how to specify a UDP transport destination port for a NetFlow-lite
collector:
Switch# config terminal
Switch(config)# netflow-lite exporter exporter1
Switch(config-netflow-lite-exporter)# destination 5.5.5.6
Switch(config-netflow-lite-exporter)# source 5.5.5.5
Switch(config-netflow-lite-exporter)# transport udp 8188
Switch(config-netflow-lite-exporter)# ttl 128
Switch(config-netflow-lite-exporter)# cos 7
Switch(config-netflow-lite-exporter)# dscp 32
Switch(config-netflow-lite-exporter)# template data timeout 1
Switch(config-netflow-lite-exporter)# options sampler-table timeout 1
Switch(config-netflow-lite-exporter)# options interface-table timeout 1
Switch(config-netflow-lite-exporter)# export-protocol netflow-v9
Switch(config-netflow-lite-exporter)# exit
Switch(config)#
transport udp destination-port
no transport udp destination-port
Specifies a UDP transport destination port for a NetFlow-lite collector.
Modification
This command was introduced on the Catalyst 4948E and Catalyst 4948E-F
Ethernet switches.
Catalyst 4500 Series Switch Cisco IOS Command Reference—Release XE 3.9.xE and 15.2(5)Ex
transport udp (netflow-lite exporter submode)
2-1141