How To Set And Add An Ac Pdc Ma01C - Huawei ECC800 User Manual

ECC800 Data Center Controller
User Manual

8.1.8.11 How to Set and Add an AC PDC MA01C?

Prerequisites
The first and second wires at one end of a network cable have been connected to pins 5 and 6
on the signal terminal block in the AC PDC MA01C, and the other end has been connected to
the COM port on the ETH converter.
Procedure
Step 1 Log in to the ECC800 WebUI as an administrator.
Step 2 Add an AC PDC MA01C.
1.
Table 8-12 Adding an AC PDC MA01C
Path
Choose System
Settings >
Device
Management
and click Add
Device. The
parameters for
adding devices
are displayed.
2.
----End
Issue 05 (2019-09-16)
Add an AC PDC MA01C.
Parameter
Name
Device attribute
Device Type
Connect To
Communications
Port
Device Address
Click Test Connect to check whether the AC PDC MA01C connects to the ECC800
properly.
− If the AC PDC MA01C connects to the ECC800 properly, click Confirm. The
connected devices are displayed in the Number of connected devices list.
− If the AC PDC MA01C does not connect to the ECC800 properly, check whether
the cable between the AC PDC MA01C and the ECC800 is connected properly,
whether the AC PDC MA01C and ECC800 are running properly, and whether the
input parameters are consistent with the AC PDC MA01C parameters.
Copyright © Huawei Technologies Co., Ltd.
Setting
Select PDU from the drop-down list box.
Select AC_PDC_MA01C from the drop-down list
box.
Select ETH Converter n from the drop-down list
box.
Select COM1/COM2 from the drop-down list box.
In this example, Device Address is set to 1. During
actual configuration, set the device address based
on the actual situation.
8 FAQ
197