Huawei ECC800 User Manual page 154

ECC800 Data Center Controller
User Manual
Figure 6-38 Power configuration
Step 5 Click Finish after checking that electricity has been configured for all IT cabinets, network
cabinets, and smart cooling products.
Step 6 Click Exit Edit Mode to exit the view editing page of the smart module.
Step 7 Choose Monitoring > Cabinet, and set Cabinet load factor overhigh alarm threshold
(default value: 90) on the Running Parameters page. For example, if you set the alarm
threshold for the cabinet load rate to 90%, an alarm is generated when the load rate of the
device in the smart module exceeds 90% of the rated power of the cabinet.
----End
Issue 05 (2019-09-16)
 If Apply to all cabinets is selected, all other cabinets use this configuration.
If Clear the power distribution configuration of all cabinets is selected, the power distribution

configuration of all cabinets will be cleared.
The alarm hysteresis is 5% by default. That is, if the cabinet load factor overhigh alarm threshold is 90%,
the raised alarm will be cleared when the load factor drops to a value smaller than 85%.
Copyright © Huawei Technologies Co., Ltd.
6 Feature Description
144