Huawei ECC800 User Manual page 107

ECC800 Data Center Controller
User Manual
Address
4
Step 2 Check the eLight function.
Table 5-6 Function check
Check Method
Choose Maintenance > Configuration
Wizard > Linkage Test > eLight
Controller Commissioning and click Test.
Step 3 Set eLight parameters.
1.
2.
Table 5-7 Access authorization
Access authorization
Access authorization fails and the aisle door
cannot be opened
Access authorization succeeds and the door
can be opened
Issue 05 (2019-09-16)
Toggle
Switch 1
OFF
Log in to the ECC800 WebUI as an administrator.
In the Smart Module View, click Modify Device. Select an eLight actuator under
Devices, drag it to the access actuator to which you want to bind the eLight actuator, and
click Exit Edit Mode.
Figure 5-10 eLight actuator position
Copyright © Huawei Technologies Co., Ltd.
Toggle Toggle
Switch 2 Switch 3
OFF ON
Normal Connection Status
The eLight is lit up in red, green, blue, and
white in sequence for 3seconds respectively,
and then turns off.
Description
Red light, blinking for 3 seconds
Green light, blinking for 3 seconds
5 Power-On Commissioning
Toggle
Switch 4
OFF
97