Configuring Pue User-Defined Mode - Huawei ECC800 User Manual

ECC800 Data Center Controller
User Manual

6.4.2 Configuring PUE User-defined Mode

Context
This section describes how to configure PUE for the integrated PDC connected.
The functions of configuration buttons for the PUE user-defined mode are described as
follows.
Table 6-23 PUE configuration buttons
No.
1
2
Procedure
Step 1 Log in to the ECC800 WebUI as an administrator.
Step 2 Choose System Settings > PUE Configuration.
Step 3 Ensure that PUE function is set to Enable.
Step 4 Set PUE configuration mode to User-defined, and click Submit.
1.
2.
Issue 05 (2019-09-16)
Button Description
Add Adds new total power consumption or IT power consumption parameters.
Delete Deletes a parameter setting for the total power consumption or IT power
consumption.
On the Total Power Consumption Configuration tab page, click Add to enter the
Total Power Consumption Configuration page. On the Select Device tab page, select
Integrated PDU 1. On the Select Indicators tab page, select Total active electricity
energy of PDU input, and click Confirm.
Figure 6-32 Total power consumption configuration
On the IT Cabinet Power Consumption Configuration tab page, click Add to enter
the IT Cabinet Power Consumption Configuration page. On the Select Device tab
page, select Integrated PDU1 and on the Select Indicators tab page, select 1QF4
electricity energy, 1QF5 electricity energy, and 1QF6 electricity energy, and click
Confirm.
Copyright © Huawei Technologies Co., Ltd.
6 Feature Description
135