How Should I Add Devices Accessed Through The Ecc800 Ai/Di Port To The Ecc800 Webui - Huawei ECC800 User Manual

ECC800 Data Center Controller
User Manual
1.
2.
Table 8-41 Parameter description for adding a device
Path
Choose System
Settings >
Device
Management
and click Add
Device. The
parameters for
adding devices
are displayed.
3.
----End
Follow-up Procedure
Choose Home > Plan View on the ECC800 WebUI, and drag the device to the corresponding
position in the Smart Module View pane based on the actual device layout.
8.1.31 How Should I Add Devices Accessed Through the ECC800
AI/DI Port to the ECC800 WebUI
Prerequisites
This section uses the device connecting to the AI/DI_1 port on the ECC800 as an example.
Issue 05 (2019-09-16)
Log in to the ECC800 WebUI as an administrator.
Add the device.
Parameter
Device attribute
Device Type
Connect To
Communications
Port
Device Address
Click Test Connect to check whether the device connects to the ECC800 properly.
− If the independent deployment AI_DI unit connects to the ECC800 properly, click
Confirm. The connected devices are displayed in the Number of connected
devices list.
− If the connection is not proper, check that the cable is properly connected between
the device and the ECC800, that the device and ECC800 are running properly, and
that the input parameters are consistent with the device parameters.
Copyright © Huawei Technologies Co., Ltd.
Setting
Select the device attribute to be accessed from the
drop-down list box.
Select the device type to be accessed from the
drop-down list box.
Select ECC800 from the drop-down list box.
Select COM1 from the drop-down list box.
NOTE
The setting example indicates that the device connects to
the COM1 port on the ECC800. If the device connects to
another port, enter the number of the connected port.
This section uses 1 as an example. In practice, set
this parameter to be the same as the
communications address for the device.
8 FAQ
243