Commissioning An Access Control Device And A Cabinet Electronic Lock - Huawei ECC800 User Manual

ECC800 Data Center Controller
User Manual
Check Method
Close and then open the door.
----End
6.1.2 Commissioning an Access Control Device and a Cabinet
Electronic Lock
If an access control device and cabinet electric lock are installed, perform the following steps
to configure it.
Prerequisites


Procedure
Step 1 Set the access user management and access permission management.
1.
2.
Issue 05 (2019-09-16)
A maximum of eight access actuators are supported.
When the fingerprint reader is connected to the ECC800 for the first time, the
permissions need to be synchronized.
Choose System Settings > Access Management to access the access management page.
The system supports the management of various access permissions through the access
card, password, and fingerprint.
On the Authorization Operations tab page, click Add to access the new user page. On
the Basic Info tab page, enter User name and Employee ID.
Specify the following information on the Password tab.
− Password: Enter and confirm the password.
− Card number: The card number can be recorded directly or by swiping the card.
 Record directly: Type the access card number in the text box.
 Record by swiping the card: Click Swipe Card and place the card on the
access control device. The card number is automatically recorded.
− Fingerprint: On the Fingerprint tab page, select Fingerprint for Select fingerprint
reader and click Collect. On the Please collect fingerprint page, click OK. Then
put your finger on the fingerprint reader to collect the fingerprint after hearing the
voice prompt. After you hear a beep sound, move your finger away and collect the
fingerprint again.
 Each fingerprint should be recorded three times.
 A maximum of three fingerprints from different fingers can be recorded.
Copyright © Huawei Technologies Co., Ltd.
Normal Connection Status
If the alarm is enabled for the front and rear doors, a
cabinet door open alarm is displayed on the active
alarm screen of the app or the active alarm page of the
WebUI.
6 Feature Description
101