Huawei ECC800 User Manual page 251

ECC800 Data Center Controller
User Manual
Procedure
Step 1 Set communications parameters on the device.
Table 8-38 Description of communications parameters to be set on a device
Parameter
Baud rate
Communications address
Step 2 Add the device to the ECC800 WebUI.
1.
2.
Table 8-39 Parameter description for adding a device
Path
Choose System
Settings >
Device
Management
and click Add
Device. The
parameters for
adding devices
are displayed.
3.
Issue 05 (2019-09-16)
Log in to the ECC800 WebUI as the administrator.
Add the device.
Parameter
Device attribute
Device Type
Connect To
Communications
Port
Device Address
Click Test Connect to check whether the device connects to the ECC800 properly.
− If the independent deployment AI_DI unit connects to the ECC800 properly, click
Confirm. The connected devices are displayed in the Number of connected
devices list.
− If the connection is not proper, check that the cable is properly connected between
the device and the ECC800, that the device and ECC800 are running properly, and
that the input parameters are consistent with the device parameters.
Copyright © Huawei Technologies Co., Ltd.
Recommended Value
This section uses 9600 as an example. Set this parameter
based on site requirements.
NOTE
For certain devices, this parameter does not need to be set.
This section uses 1 as an example. Set this parameter based on
site requirements.
Setting
Select the device attribute to be accessed from the
drop-down list box.
Select the device type to be accessed from the
drop-down list box.
Select the corresponding ETH converter from the
drop-down list box.
NOTE
Use the blinking function of the ETH converter to identify
the mapping between the device and the ETH converter.
Select COM1/COM2 from the drop-down list box.
This section uses 1 as an example. In practice, set
this parameter to be the same as the
communications address for the device.
8 FAQ
241