Configuring System Message Logging; About System Message Logging - Cisco AP775A - Nexus Converged Network Switch 5010 Configuration Manual

Fabric manager configuration guide, release 4.x

Hide thumbs Also See for AP775A - Nexus Converged Network Switch 5010:

Table of Contents

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

Configuring System Message Logging

This chapter describes how to configure system message logging on Cisco MDS 9000 Family switches.

It includes the following sections:

You can monitor system messages by clicking the Events tab on Fabric Manager or by choosing Logs >

Events > Current on Device Manager. You can also monitor system messages remotely by accessing

the switch through Telnet, SSH, or the console port, or by viewing the logs on a system message logging

When the switch first initializes, the network is not connected until initialization completes. Therefore,

messages are not redirected to a system message logging server for a few seconds.

Log messages are not saved across system reboots. However, a maximum of 100 log messages with a

severity level of critical and below (levels 0, 1, and 2) are saved in NVRAM.

Facility Keyword

OL-17256-03, Cisco MDS NX-OS Release 4.x

About System Message Logging, page 61-1

System Message Logging Configuration, page 61-3

Default Settings, page 61-11

describes some samples of the facilities supported by the system message logs.

Internal Logging Facilities

All facilities

Authorization system

Authorization (private) system

Cron or at facility

System daemons

C H A P T E R

Standard or Cisco MDS Specific

Cisco MDS 9000 Family specific

Cisco MDS 9000 Family specific

Cisco MDS 9000 Family Fabric Manager Configuration Guide

Show Quick Links

Table of Contents