Clear The Contbus-Io-A Alarm; Ctneqpt-Pbprot - Cisco ONS 15310-CL Troubleshooting Manual

Chapter 1 Alarm Troubleshooting
A 15310-CL-CTX A or CTX2500 to Shelf Slot Communication Failure alarm occurs when the
cross-connecting card (in this platform, the controller card) has lost communication with another card
slot in the shelf. The other card is identified by the Object column in the CTC alarm window.

Clear the CONTBUS-IO-A Alarm

Ensure that the reporting card is physically present in the shelf. Record the card type. Click the
Step 1
Inventory tab and view the Eqpt Type column to reveal the provisioned type.
If the actual card type and the provisioned card type do not match, see the
page 1-110
Complete the
Step 2
Avoid soft-resetting multiple ONS 15310-MA cards at one time; doing so might cause an unexpected
Caution
traffic hit.
For LED behavior, see the
Wait ten minutes to verify that the card you reset completely reboots.
If CONTBUS-IO-A is raised on more than one card at once, complete the
Step 3
Controller Card" procedure on page
Avoid soft-resetting multiple ONS 15310-MA cards at one time; doing so might cause an unexpected
Caution
traffic hit.
Verify that the reset is complete and error-free and that no new related alarms appear in CTC. A green
Step 4
ACT LED indicates an active card.
If the reset card has not rebooted successfully, or the alarm has not cleared, call Cisco TAC (1 800
Step 5
553-2447).

1.7.44 CTNEQPT-PBPROT

The Interconnection Equipment Failure Protect Cross-Connect Card Payload Bus Alarm indicates a
failure of the main payload between the protect CTX2500 Slot 4 cross-connect card and the reporting
traffic card. The cross-connect card and the reporting card are no longer communicating through the
backplane. The problem exists in the cross-connect card and the reporting traffic card, or the controller
card and the backplane.
This alarm automatically raises and clears when the Slot 4 controller card is reseated.
Note
78-17235-01
for the reporting card.
"Soft- or Hard-Reset an Ethernet or Electrical Card in CTC" procedure on page
"1.9.2 Typical Card LED Activity During Reset" section on page
Default Severity: Critical (CR), Service-Affecting (SA) for ONS 15310-MA
SONET Logical Object: EQPT
1-154.
Cisco ONS 15310-CL and Cisco ONS 15310-MA Troubleshooting Guide, R7.0
1.7.44 CTNEQPT-PBPROT
"MEA (EQPT)" alarm on
1-154.
1-148.
"Soft- or Hard-Reset a
1-41