Cisco ONS 15310-CL Troubleshooting Manual page 294

Table 1-1 Error Messages (continued)
Error Warning
ID Error Warning Message
EID-3072 Clear Learned Address
EID-3073 Clear Selected Rows
EID-3074 Clear By {0}
EID-3075 At least one row in param column needs to be selected.
EID-3076 CTC lost its connection with this node. The NE Setup Wizard
will exit.
EID-3077 No optical link selected.
EID-3078 Unable to create optical link.
EID-3079 Cannot apply defaults to node: {0}
EID-3080 Cannot go to the target tab {0}
EID-3081 Port type cannot be changed.
EID-3082 Cannot modify the {0} extension byte.
EID-3084 Error encountered while trying to retrieve laser parameters for
{0}
EID-3085 No OSC Terminations selected
EID-3086 One or more Osc terminations could not be created.
EID-3087 OSC termination could not be edited.
EID-3088 No {0} card to switch.
EID-3089 Cannot use/change {0} state when {1} is failed or missing.
EID-3090 Cannot perform operation as {0} is
{1}LOCKED_ON/LOCKED_OUT.
EID-3091 Cannot perform the operation as protect is active.
EID-3092 Invalid service state. The requested action cannot be applied.
EID-3093 Cannot perform the operation as duplex pair is {0}locked.
EID-3094 Cannot perform the operation as no XC redundancy is
available.
EID-3095 Deletion failed since the circuit is in use
WID-3096 Internal communication error encountered while trying to
retrieve laser parameters. This can happen when equipment is
not present or when equipment is resetting. Check the
equipment state and try to refresh the values again.
Cisco ONS 15310-CL and Cisco ONS 15310-MA Troubleshooting Guide, R7.0
1-18
Chapter 1
Description
Failure attempting to clear the learned MAC
address from a specific card or Ether group.
Failure attempting to clear the learned MAC
address from a specific card or Ether group.
Error encountered trying to clear the
learned MAC address from either a VLAN
or a port.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
CTC cannot apply the defaults to the
specified node.
CTC cannot go to the specified target tab.
Refer to the error message text.
You cannot modify the specified extension
byte.
There is no card, or there was an internal
communications error when attempting to
get the laser parameters for the card.
Select an OSC termination and proceed.
Refer to the error message text.
Refer to the error message text.
No card of the specified type to switch.
Cannot use or change the specified state
when the card is failed or missing.
Cannot perform operation.
Refer to the error message text.
Select another service state and proceed.
Refer to the error message text.
You cannot perform the requested operation
on the cross connect card without having a
backup cross connect card.
Refer to the error message text.
Refer to the warning message text.
Error Messages
78-17235-01