Cisco ONS 15310-CL Troubleshooting Manual page 293

Chapter 1 Error Messages
Table 1-1 Error Messages (continued)
Error Warning
ID Error Warning Message
EID-3050 An exception was caught trying to save the file to your local file
system.
EID-3051 The maximum size for a config file in bytes is: {0}
EID-3052 There was an error saving the config file to the TCC.
EID-3053 The value of {0} must be between {1} and {2}
EID-3054 Cannot remove provisioned input/output ports or another user
is updating the card, please try later.
EID-3055 Cannot create soak maintance pane.
EID-3056 Cannot save defaults to file {0}
EID-3057 Cannot load default properties from the node.
EID-3058 File {0} does not exist.
EID-3059 Error encountered while refreshing.
EID-3060 The ALS Recovery Pulse Interval must be between {0} seconds
and {1} seconds.
EID-3061 The ALS Recovery Pulse Duration must be between {0}
seconds and {1} seconds.
EID-3062 Error encountered while setting values.
EID-3064 Not a G1000 Card.
EID-3065 An error was encountered while attempting to create RMON
threshold:
{0}
EID-3066 Minimum sample period must be greater than or equal to 10.
EID-3067 Rising Threshold: Invalid Entry, valid range is from 1 to {0}
EID-3068 Falling Threshold: Invalid Entry, valid range is from 1 to {0}
EID-3069 Rising threshold must be greater than or equal to falling
threshold.
EID-3070 Error in data for ports {0} Exactly one VLAN must be marked
untagged for each port. These changes will not be applied.
EID-3071 Get Learned Address
78-17235-01
Cisco ONS 15310-CL and Cisco ONS 15310-MA Troubleshooting Guide, R7.0
Description
Check whether the file already exists and
cannot be over written, or there isa space
constraint in the file system.
The size of the configuration file should not
exceed the specified number of bytes.
Refer to the error message text.
The value of the item must be between the
specified values.
Another user may be updating the card. You
can try again later.
Refer to the error message text.
CTC cannot save the defaults to the
specified file.
Refer to the error message text.
Refer to the error message text.
There was an error while refreshing.
The automatic laser shutdown (ALS)
Recovery Interval must be between the
specified range of seconds.
The automatic laser shutdown (ALS)
Recovery Duration must be between the
specified range of seconds.
Refer to the error message text.
This card is not a G1000-4 card.
You must wait some time before you try
again.
Refer to the error message text.
This is an invalid rising threshold entry. The
valid range is from 1 to the specified value.
This is an invalid falling threshold entry.
The valid range is from 1 to the specified
value.
Refer to the error message text.
CTC encountered data error for the
specified ports. Only one VLAN should be
marked untagged for each port.
Unable to retrieve the learned MAC address
from the NE.
1-17