Cisco ONS 15310-CL Troubleshooting Manual page 296

Table 1-1 Error Messages (continued)
Error Warning
ID Error Warning Message
EID-3120 No object of type {0} selected to delete.
EID-3121 Error Deleting {0}
EID-3122 No object of type {0} selected to edit.
EID-3123 Error Editing {0}
EID-3124 {0} termination is in use.
Delete the associated OSPF Range Table Entry and try again
EID-3125 No {0} Terminations selected.
EID-3126 {0} termination could not be edited.
EID-3127 Unable to provision orderwire because E2 byte is in use by {0}. Refer to the error message text.
EID-3128 The authentication key may only be {0} characters maximum
EID-3129 The authentication keys do not match!
EID-3130 Error creating OSPF area virtual link.
EID-3131 Error creating OSPF virtual link.
EID-3132 Error setting OSPF area range: {0}, {1}, false.
EID-3133 Max number of OSPF area ranges exceeded.
EID-3134 Invalid Area ID. Use DCC OSPF Area ID, LAN Port Area ID,
or 0.0.0.0.
EID-3135 Invalid Mask
EID-3136 Invalid Range Address
EID-3137 Your request has been rejected because the timing source
information was updated while your changes were still
pending. Please retry.
EID-3138 Invalid clock source for switching.
EID-3139 Cannot switch to a reference of inferior quality.
EID-3140 Higher priority switch already active.
EID-3141 Attempt to access a bad reference.
EID-3142 No Switch Active.
EID-3143 Error creating static route entry.
Cisco ONS 15310-CL and Cisco ONS 15310-MA Troubleshooting Guide, R7.0
1-20
Chapter 1
Description
Choose an object of the specified type to
delete.
There is an error deleting the item.
Choose an object of the specified type to
edit.
There was an error editing the item.
Refer to the error message text.
No specified terminations are selected.
CTC could not edit the specified
termination.
The authentication key cannot exceed the
specified number of characters.
Refer to the error message text.
CTC encountered an error while creating
the area virtual link.
CTC encountered an error creating the
virtual link.
CTC encountered an error while setting the
area range for the specified values.
OSPF area ranges exceeded the maximum
number.
Refer to the error message text.
Refer to the error message text.
The range address is invalid. Try again.
Refer to the error message text.
You have selected an invalid clock source.
Choose another clock.
Refer to the error message text.
You cannot switch the timing source
manually when a higher priority switch is
already active.
Refer to the error message text.
None of the switches are active.
CTC encountered an error while a creating
static route entry.
Error Messages
78-17235-01