Autolsroff; Autoreset; Clear The Autoreset Alarm; Autosw-Ais - Cisco ONS 15310-CL Troubleshooting Manual

1.7.23 AUTOLSROFF

1.7.23 AUTOLSROFF
The AUTOLSROFF ALARM is not used in the ONS 15310 platforms in this release. It is reserved for
development.

1.7.24 AUTORESET

The Automatic System Reset alarm occurs when you change an IP address or perform any other
operation that causes an automatic card-level reboot.
AUTORESET typically clears after a card reboots (up to ten minutes). If the alarm does not clear,
complete the following procedure.

Clear the AUTORESET Alarm

Determine whether additional alarms are present that could have triggered an automatic reset. If so,
Step 1
troubleshoot these alarms using the applicable section of this chapter.
If the reporting card is an ML-100T-8 or CE-100T-8 card and automatically resets more than once a
Step 2
month with no apparent cause, complete the
Always use the supplied electrostatic discharge wristband when working with a powered ONS 15310-CL
Caution
or ONS 15310-MA.
Note
If the alarm does not clear, log into the Technical Support Website at http://www.cisco.com/techsupport
Step 3
for more information or call Cisco TAC (1 800 553-2447).

1.7.25 AUTOSW-AIS

The Automatic Path Protection Switch Caused by an AIS condition indicates that automatic path
protection switching occurred because of an AIS condition. If the path protection is configured for
revertive switching, it reverts to the working path after the fault clears. The AIS also clears when the
upstream trouble is cleared.
This condition is only reported if the path protection is set up for revertive switching.
Note
Cisco ONS 15310-CL and Cisco ONS 15310-MA Troubleshooting Guide, R7.0
1-28
Default Severity: Minor (MN), Non-Service-Affecting (NSA)
SONET Logical Object: EQPT
When you replace a card with the identical type of card, you do not need to make any changes
to the database.
Default Severity: Not Reported (NR), Non-Service-Affecting (NSA)
SONET Logical Objects: STSMON, VT-MON
"Physically Replace a Card" procedure on page
Chapter 1 Alarm Troubleshooting
1-155.
78-17235-01