Cisco ONS 15310-CL Troubleshooting Manual page 292

Table 1-1 Error Messages (continued)
Error Warning
ID Error Warning Message
EID-3021 An error was encountered while retrieving the diagnostics:
{0}
EID-3022 Requested action not allowed.
EID-3023 Unable to retrieve low order cross connect mode.
EID-3024 Unable to switch {0} cross connect mode.
Please verify that the type and/or number of circuits
provisioned does not exceed the criterion for switching modes.
EID-3025 Error while retrieving thresholds.
EID-3026 Cannot modify send DoNotUse.
EID-3027 Cannot modify SyncMsg.
EID-3028 Cannot change port type.
EID-3029 Unable to switch to the byte because an overhead change is
present on this byte of the port.
EID-3031 Error hard-resetting card.
EID-3032 Error resetting card.
EID-3033 The lamp test is not supported on this shelf.
EID-3035 The cross connect diagnostics cannot be performed
EID-3036 The cross connect diagnostics test is not supported on this shelf. The cross-connect diagnostics test is not
EID-3039 Card change error.
EID-3040 Invalid card type.
EID-3041 Error applying changes.
EID-3042 The flow control low value must be less than the flow control
high value for all ports in the card.
EID-3046 The flow control water mark value must be between {0} and
{1}, inclusive.
EID-3047 The file named {0} could not be read. Please check the name
and try again.
EID-3048 There is no IOS startup config file available to download.
EID-3049 There is an update in progress so the download cannot be done
at this time.
Cisco ONS 15310-CL and Cisco ONS 15310-MA Troubleshooting Guide, R7.0
1-16
Chapter 1
Description
Refer to the error message text.
The requested action is not allowed.
Refer to the error message text.
CTC cannot switch the cross-connect mode
for the specified item, as the type or the
number of circuits does not match with the
criterion for switching modes.
There was an error retrieving the thresholds.
You cannot modify the Send DoNotUse
field.
You cannot modify the SyncMsg field.
You cannot change the port type.
Refer to the error message text.
There was an error while resetting card
hardware.
There was an error while resetting the card.
Refer to the error message text.
Refer to the error message text.
supported on this shelf.
There was an error while changing the card.
The selected card type is invalid.
CTC is unable to create a protection group.
Check if the protect port supports circuits, a
timing reference, SONET SDCC,
orderwire, or a test access point.
Refer to the error message text.
The flow control watermark value must be
between the two specified values.
Refer to the error message text.
CTC could not find the configuration file
for IOS startup.
Refer to the error message text.
Error Messages
78-17235-01