Cisco ONS 15310-CL Troubleshooting Manual page 314

Table 1-1 Error Messages (continued)
Error Warning
ID Error Warning Message
EID-6049 Mode {0} is not supported.
EID-6050 Some {0} terminations were not {1}d.
{2}
WID-6051 All {0} terminations were {1}d successfully.
{2}
EID-6052 The authentication key can not be blank.
EID-6053 No more SNMP trap destinations can be created.
EID-6054 {0} is not a valid IP address for an SNMP trap destination.
EID-6055 The IP address is already in use.
EID-6056 Invalid SNMP trap destination. {0}
WID-6057 Changing the card mode will result in an automatic reset.
EID-6058 Max number of IP Over CLNS tunnels exceeded.
EID-6059 The specified IP Over CLNS tunnel already exists!
EID-6060 Cannot {0} IP Over CLNS tunnel entry:
{1}.
EID-6061 Error deleting IP Over CLNS tunnel entry.
EID-6062 Selected IP Over CLNS tunnel does not exist.
EID-6063 Selected router does not exist.
EID-6064 MAA address list is full.
EID-6065 Selected area address is duplicated.
EID-6066 Primary area address can not be removed.
EID-6067 Selected area address does not exist.
EID-6068 The IP Over CLNS NSEL may not be modified while there are
IP Over CLNS Tunnel Routes provisioned.
EID-6069 The node is currently in ES mode. Only router #1 may be
provisioned.
EID-6070 No router selected.
EID-6071 Cannot flush TARP data cache.
EID-6072 Cannot add TARP data cache entry:
{0}
WID-6073 TARP request has been initiated.
Try refreshing TARP data cache later.
Cisco ONS 15310-CL and Cisco ONS 15310-MA Troubleshooting Guide, R7.0
1-38
Chapter 1
Description
CTC does not support the mode of
operation requested on the card.
Refer to the error message text.
Refer to the warning message text.
Enter an authentication key.
You have reached the maximum number of
SNMP trap destinations.
The IP address specified is not a valid
receiver of SNMP traps.
Refer to the error message text.
The specified SNMP trap destination is
invalid. Choose another destination.
Refer to the warning message text.
Refer to the error message text.
Specify another IP Over CLNS tunnel.
Refer to the error message text.
CTC encountered an error while deleting
the IP Over CLNS tunnel entry.
Create a IP Over CLNS tunnel.
Create a router.
Refer to the error message text.
Enter another area address.
Refer to the error message text.
Choose another area address.
You cannot change the NSEL address if
tunnels are provisioned.
An End System needs only one provisioned
router.
Select a router.
You cannot flush the cache in the Tunnel
identifier Address Resolution Protocol
(TARP) state.
You cannot add the specified cache entry.
Refer to the warning message text.
Error Messages
78-17235-01