Cisco ONS 15310-CL Troubleshooting Manual page 303

Chapter 1 Error Messages
Table 1-1 Error Messages (continued)
Error Warning
ID Error Warning Message
EID-3294 No RMON thresholds available for selected port.
EID-3295 This card does not support RMON thresholds.
EID-3296 Buffer-to-buffer credit is only supported for Fibre Channel (FC)
and FICON.
EID-3298 ALS Auto Restart is not supported by this interface.
EID-3300 Can not have duplicate OSPF area IDs.
EID-3301 LAN metric may not be zero.
EID-3302 Standby {0} not ready.
EID-3303 DCC Area ID and {0} conflict.
{1}
EID-3304 DCC number is out of range.
EID-3305 Can not have OSPF turned on on the LAN interface and the
back bone area set on a DCC interface.
EID-3306 Ethernet circuits must be bidirectional.
EID-3307 Error while creating connection object at {0}.
EID-3308 DWDM Link can be used only for optical channel circuits.
EID-3309 OCH-NC circuit: link excluded - wrong direction.
EID-3310 DWDM Link does not have wavelength available.
EID-3311 Laser already on.
EID-3312 Unable to change the power setpoint {0} {1}
EID-3313 Unable to modify offset. Amplifier port is in service state.
EID-3314 Requested action not allowed. Invalid state value.
EID-3315 Unable to perform operation.
EID-3316 Wrong node side.
EID-3317 Name too long.
EID-3318 Illegal name.
EID-3319 Wrong line selection.
EID-3320 Unable to delete optical link.
EID-3321 This feature is unsupported by this version of software.
EID-3322 Equipment is not plugged-in.
78-17235-01
Cisco ONS 15310-CL and Cisco ONS 15310-MA Troubleshooting Guide, R7.0
Description
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
OSPF area IDs should be unique.
Refer to the error message text.
Standby controller card is not ready.
DCC Area ID and ring type, specified by
{0}, conflict each other due to the details
specified by {1}.
Enter a DCC number that is within the range
You cannot have the default OSPF area on a
DCC while OSPF is enabled on the LAN.
Refer to the error message text.
CTC encountered an error at the specified
connection while creating the connection.
Refer to the error message text.
The optical channel (circuit) does not allow
the specified link to be included because it
is in the wrong optical direction.
Refer to the error message text.
Refer to the error message text.
CTC cannot change change the power
setpoint. The new setpoint would either
make the thresholds inconsistent or set the
fail threshold outside the range.
Refer to the error message text.
Refer to the error message text.
CTC is unable to perform operation.
This task was applied to the wrong node
side.
Reduce the number of charcters in the
name.
The name you entered is illegal.
Select another line
CTC cannot delete the optical link.
Refer to the error message text.
Plug-in the equipment and proceed.
1-27